DIY Color Block Umbrella Table

I am proud to be a 3M- sponsored blogger, and, as part of my responsibilities, I get the opportunity to evaluate new products from ScotchBlue™ Painter’s Tape. Opinions are my own and additional product used in the project were selected by me.

I’m so excited to be joining in the Get It, Got It, Go Blog Hop being hosted by Kate at Centsational Girl!

Be sure to check out the amazing projects featuring ScotchBlue™ Painter’s Tape and The Home Depot!  I’m sharing a fun outdoor project: a DIY color block umbrella table!

DIY color block umbrella table

This planked table project is simple enough for the beginner builder and the color block painting adds a fun and colorful element just perfect for summer!

To build the table, you’ll need the following supplies from The Home Depot: 4 2×2-inch pieces cut to a length of 19 inches, 4 2×2-inch pieces cut to a length of 16 inches, 2 1×6-inch pieces cut to a length of 20 inches, 18 1×4-inch pieces cut to a length of 20 inches, 1 1×6-inch piece cut to a length of 19 inches, and 4 1×4-inch pieces cut to a length of 19 inches.  In addition you’ll need wood screws, tools, and ScotchBlue™ Painter’s Tape.

Before you begin, you’ll need the staff at The Home Depot to trim 1/2 an inch off the width of the 1×6-inch pieces.  You can also have them trim your boards to the appropriate length while you’re at it.

To build the table, I made two slightly rectangular frames by attaching two of the 19 inch 2×2′s to two of the 16 inch 2×2′s {the shorter 2×2′s will sit inside the others}.

frame D

One frame will sit at the top of the table and one frame will form the base.

box frame D

Beginning with one side of the table, lay five 1×4 planks {20 inches long} side by side, flush with the top of one frame and the bottom of the other and drill pilot holes through the planks and into the frames.  Insert wood screws into each pilot hole, ensuring that the frames are sitting square.  Repeat on the opposite side.

framed table D

Repeat the process for the other two sides, using four 1×4 inch pieces and placing a wider {trimmed} 1×6-inch piece in the middle.  The planks on these two sides will cover the frame as well as the side of the planks on the two completed sides.

With the boards that are 19 inches in length, repeat that process {using a wider board in the middle} to form the top of the table.  Before screwing down the middle board, lay a board diagonally across the top and mark the center …

center of top D

… then drill a hole large enough to hold an umbrella post.  Secure the plank to the top of the table.

hole for umbrella D

Now that the building part is done, it’s time for the fun stuff: the painting!

Before you paint, sand all the rough edges and wipe the table down to remove all dust.

Since you’re only going to paint the lower half of the table, measure evenly around the table and place ScotchBlue™ Painter’s Tape along your measured line.  I used Exterior tape for this project.

scotchblue painter's tape D

Above the initial line of ScotchBlue™ Painter’s Tape, add a couple of extra lines of tape to block paint spray.

scotchblue D

Using a bright color, spray paint the bottom half of the umbrella table, applying a couple of coats if needed.

spray paint D

Allow the paint to dry and spray a coat of clear sealer to provide some protection from the elements.

Place an umbrella stand inside the table for support …

umbrella table D

… and enjoy the shade of your new color-blocked umbrella table!

pool seating D

This shady spot is where I’ll be spending my summer, sipping tea and watching the kids in the pool!

umbrella table seating D

Want to do a little painting of your own?

Enter to win a $50 Home Depot eGiftCard using rafflecopter below!

a Rafflecopter giveaway

For more inspiration, follow ScotchBlue™ on facebook, twitter, and pinterest, and follow The Home Depot on facebook, twitter, and pinterest!

And for more blog hop projects, click on the links below:

320 Sycamore  |  Centsational Girl  |  Domestically Speaking  |  Brooklyn Limestone  |  Simply Designing

Randi Dukes About Randi Dukes

I’m Randi, a wife and stay-at-home mom of five kids, ranging from preschool to high school. I love strong coffee, craft and DIY projects, my planner, my laptop, and my big ol’ family. When I’m not creating something for my blog, I can be found in the car, running kids from one place to another. I’m the one knitting at the red light.

Comments

  1. I love this project, idea, Randi. It turned out great.

  2. Turned out so pretty! Love it!

  3. LOVE this project, Randi! The colors are fabulous!

  4. That is so amazing Randi! What a neat idea!

  5. What a fabulous idea Randi!

  6. What a great table! I love the bright color!

  7. Turned out amazing, Randi!! Loving that pop of color!

  8. Wow, this is amazing. And nice pop of color!

  9. Randi, this is one of my favorite projects I’ve seen and I love the night tight lines you got using the Scotch Blue. I have a huge shopping list for summer projects…adding this tape.

  10. Love this! Fun color choices!

  11. Love the color block effect! I love Scotch blue!

  12. This is so, so cute!

  13. great idea, and so do-able!

  14. LOVE this!!! the colour blocking is so fresh and modern looking, pinned!!!

  15. I love that table – simple and modern!

Speak Your Mind

*